Essential Pre Requisites:
- Backup all the data present in your FIT S5670L as in the process of applying this firmware, the data in the device may get deleted or corrupted.
Text messages – Use “SMS Backup & Restore app”,
Phone Contacts – Sync with the Gmail application,
Call Log - Call Log and Restore
Pictures, Music, Videos, Files etc.– Copy to internal / External SD Card,
Internet & MMS Settings – Backup all the settings from the path “Applications > Settings > Wireless and Network > Mobile Networks > Access Point Names”
Notes – Manually you need to note down or need to transfer to Evernote.
- Battery left in the device should be a minimum of 60% so as to ensure that the device doesn’t get turned Off in the middle of firmware update. Enable the USB Debugging in your device from the path “Settings > Applications > Development > USB debugging”.
So, assuming that all the above instructions are followed successfully you are now ready to proceed with the procedure mentioned in the next page.
Procedure to Update Galaxy FIT S5670L with Gingerbread 2.3.6:
- Download the Gingerbread 2.3.6 Firmware Zip Package to your computer. In the process of extraction, you will be prompted to enter the password. Enter the password as “androidadvices.com”.
- Once you extract the files, you need to check with the extracted files from the below mentioned screen capture. Even if single file is missing, you need to check with the extraction or download process. The file size of the zip package is 108.9 MB.
- From extracted files, open Odin executable file and turn Off the phone so as to enter the device in the download mode.
- The download mode can be entered by holding the Volume Down button + the Home key button (the middle button). While holding these both buttons, you need to switch ON your device. If the device boots up in the normal mode then you need to again try entering the download mode.
- Connect the phone to the computer while keeping the Odin opened. Within a minute, the ID : COM section will turn yellow which will mean that all the drivers have been successfully installed and you are now ready to proceed to the next step. If ID : COM section doesn’t turn yellow then you need to check with the USB Drivers as well as the KIES tool.
- Now, Click on the “OPS” option in the Odin to select the below mentioned file, tick on “One Package” option and then select the One Package option as mentioned below.
OPS – BENI_v1.0.ops
ONE PACKAGE – S5670LUBKPI_S5670LUJKPI_S5670LCHLKP4_HOME.tar.md5
- Click on the “Start” tab to start the process of firmware update. Once the firmware is updated successfully, the device will be rebooted automatically. Once you see the home screen, you now need to turn Off the phone so as to enter the device in the recovery mode.
- Select “Wipe data / Factory Reset” and “Wipe cache partition” to clear all the cache files if any present in your phone. After this, select “++++ Go Back ++++” and select the option of “Reboot System Now” for restarting the device.
To check whether the firmware is updated successfully or not, you need to check the same from the path Settings > About Phone > Firmware Version where you will find the version of Android OS where it will show UBKPI 2.3.6. If the firmware version is different then that means the firmware wasn’t updated successfully and you need to apply the same again.
Disclaimer: At Android Advices, we have made sure in all respects that all the information regarding the firmware update is mentioned correctly in this article. We should not be held responsible for any damage happened to your device in the process of updating your phone which is very unlikely if you follow the instructions.
Originally posted by :ANDROIDDEVICES,COM
FOR DETAIL INFORMATION OPEN androidadvices.com
0 comments:
Post a Comment